[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [PowerPC] New board walnut with u-boot
From: |
Salvatore Lionetti |
Subject: |
[Qemu-devel] [PowerPC] New board walnut with u-boot |
Date: |
Thu, 13 Nov 2008 22:27:28 +0000 (GMT) |
Hi,
i've ported u-boot-1.1.6 and DHT walnut board to qemu-0.9.1 environment.
At qemu side:
- LACK of flash CFI interaction, i2c, PCI support,
- CONTAIN board parameter, serial, emac full support
As result, using tun driver and tap interface, is possible to have full network
function up and running.
I've tested ping, tftp, dhcp from u-boot shell and all is ok!
(reach 80KB/sec but with cpu eated by qemu since u-boot !use idle state)
Here some spec extracted by u-boot console:
CPU: AMCC PowerPC 405GP Rev. E at 266.640 MHz (PLB=66, OPB=33, EBC=33 MHz)
Internal PCI arbiter enabled, PCI async ext clock used
16 kB I-Cache 8 kB D-Cache
Normally at work use clearcase (both UCM and cc) as versioning system.
To integrate the patch, and simplify integration, i need some info
- is the current trunk in use svn://svn.sv.gnu.org/qemu/trunk?
- could i directly deliver such work?
If yes to both question, i'll test in local, check just delivered code, test
the integration.
Have a good day
Salvatore
Unisciti alla community di Io fotografo e video, il nuovo corso di
fotografia di Gazzetta dello sport:
http://www.flickr.com/groups/iofotografoevideo
- [Qemu-devel] [PowerPC] New board walnut with u-boot,
Salvatore Lionetti <=