[Qemu-devel] Re: sparc32 fix spurious dma interrupts

[Blue Swirl]

On Thu, Feb 11, 2010 at 12:40 AM, Artyom Tarasenko
<address@hidden> wrote:
> Don't raise interrupt when not enabled.
> Don't set DMA_INTR bit spuriously.
> Don't print misleading debug messages "Raise IRQ" when not raising any.

This breaks most of my Linux tests. *BSD are unaffected. For example
sparc-test 2.0:

eth0: LANCE 52:54:00:12:34:56
esp0: IRQ 36 SCSI ID 7 Clk 40MHz CCYC=25000 CCF=8 TOut 167 NCR53C9XF(espfast)
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP100A-FAST
esp0: Aborting command
esp0: dumping state
esp0: dma -- cond_reg<a4400311> addr<f0010e64>
esp0: SW [sreg<11> sstep<04> ireg<18>]
esp0: HW reread [sreg<93> sstep<00> ireg<10>]
esp0: current command [tgt<02> lun<00> pphase<CLUELESS> cphase<DATAIN>]
esp0: disconnected
esp0: Aborting command
esp0: dumping state
esp0: dma -- cond_reg<a4400310> addr<f0010e64>
esp0: SW [sreg<11> sstep<04> ireg<18>]
esp0: HW reread [sreg<03> sstep<04> ireg<00>]
esp0: current command [tgt<02> lun<00> pphase<UNISSUED> cphase<UNISSUED>]
esp0: disconnected
esp0: Resetting scsi bus
esp0: SCSI bus reset interrupt
esp0: Aborting command
esp0: dumping state
esp0: dma -- cond_reg<a4400211> addr<f000d007>
esp0: SW [sreg<03> sstep<04> ireg<80>]
esp0: HW reread [sreg<91> sstep<04> ireg<18>]
esp0: current command [tgt<02> lun<00> pphase<UNISSUED> cphase<UNISSUED>]
esp0: disconnected
scsi: Device offlined - not ready after error recovery: host 0 channel
0 id 2 lun 0

Since Open/NetBSD still works, there may be yet again another bug that
your patch uncovers.