>From 313589d5bfb7458566eb9cfadfeaa7038f0a1622 Mon Sep 17 00:00:00 2001 From: Richard W.M. Jones Date: Fri, 24 Sep 2010 16:08:06 +0100 Subject: [PATCH] Watchdog: disable watchdog timer when hard-rebooting a guest. This commit causes the watchdog timer to be reset when a guest is hard-rebooted. The failure case previously was as follows: (a) guest boots, watchdog is enabled (b) guest does a reset eg: echo 'b' > /proc/sysrq-trigger (note that an ordinary /sbin/reboot wouldn't hit this case since as the watchdog daemon is shut down, the daemon would properly disable the watchdog device) (c) the reboot takes longer than the remaining time on the watchdog (d) the watchdog therefore fires during the reboot (e) probably the VM would just reboot again at this point which is pretty benign, but it could depend on the action that the user had selected for the watchdog Now we use the qdev reset function to register a reset handler which disables the timer. Note the handler is called _either_ just after init _or_ when the guest reboots. In the i6300esb case there is a small refactoring of the code so that the device's internal state is now fully restored to defaults on a reboot. Signed-off-by: Richard W.M. Jones --- hw/wdt_i6300esb.c | 5 ++++- hw/wdt_ib700.c | 20 ++++++++++++++++---- 2 files changed, 20 insertions(+), 5 deletions(-) diff --git a/hw/wdt_i6300esb.c b/hw/wdt_i6300esb.c index 8443b41..90bf5f6 100644 --- a/hw/wdt_i6300esb.c +++ b/hw/wdt_i6300esb.c @@ -149,6 +149,8 @@ static void i6300esb_reset(DeviceState *dev) i6300esb_disable_timer(d); + /* NB: Don't change d->previous_reboot_flag in this function. */ + d->reboot_enabled = 1; d->clock_scale = CLOCK_SCALE_1KHZ; d->int_type = INT_TYPE_IRQ; @@ -159,7 +161,6 @@ static void i6300esb_reset(DeviceState *dev) d->timer2_preload = 0xfffff; d->stage = 1; d->unlock_state = 0; - d->previous_reboot_flag = 0; } /* This function is called when the watchdog expires. Note that @@ -193,6 +194,7 @@ static void i6300esb_timer_expired(void *vp) if (d->reboot_enabled) { d->previous_reboot_flag = 1; watchdog_perform_action(); /* This reboots, exits, etc */ + i6300esb_reset(&d->dev.qdev); } /* In "free running mode" we start stage 1 again. */ @@ -409,6 +411,7 @@ static int i6300esb_init(PCIDevice *dev) i6300esb_debug("I6300State = %p\n", d); d->timer = qemu_new_timer(vm_clock, i6300esb_timer_expired, d); + d->previous_reboot_flag = 0; pci_conf = d->dev.config; pci_config_set_vendor_id(pci_conf, PCI_VENDOR_ID_INTEL); diff --git a/hw/wdt_ib700.c b/hw/wdt_ib700.c index c34687b..b6235eb 100644 --- a/hw/wdt_ib700.c +++ b/hw/wdt_ib700.c @@ -97,6 +97,8 @@ static int wdt_ib700_init(ISADevice *dev) { IB700State *s = DO_UPCAST(IB700State, dev, dev); + ib700_debug("watchdog init\n"); + s->timer = qemu_new_timer(vm_clock, ib700_timer_expired, s); register_ioport_write(0x441, 2, 1, ib700_write_disable_reg, s); register_ioport_write(0x443, 2, 1, ib700_write_enable_reg, s); @@ -104,16 +106,26 @@ static int wdt_ib700_init(ISADevice *dev) return 0; } +static void wdt_ib700_reset(DeviceState *dev) +{ + IB700State *s = DO_UPCAST(IB700State, dev.qdev, dev); + + ib700_debug("watchdog reset\n"); + + qemu_del_timer(s->timer); +} + static WatchdogTimerModel model = { .wdt_name = "ib700", .wdt_description = "iBASE 700", }; static ISADeviceInfo wdt_ib700_info = { - .qdev.name = "ib700", - .qdev.size = sizeof(IB700State), - .qdev.vmsd = &vmstate_ib700, - .init = wdt_ib700_init, + .qdev.name = "ib700", + .qdev.size = sizeof(IB700State), + .qdev.vmsd = &vmstate_ib700, + .qdev.reset = wdt_ib700_reset, + .init = wdt_ib700_init, }; static void wdt_ib700_register_devices(void) -- 1.7.3.2