[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [v6 Patch 0/4]Qemu: Set host pagecache from cmdline and mon
From: |
Supriya Kannery |
Subject: |
[Qemu-devel] [v6 Patch 0/4]Qemu: Set host pagecache from cmdline and monitor |
Date: |
Fri, 05 Aug 2011 12:26:03 +0530 |
Currently cache setting of a block device cannot be changed
without restarting a running VM. Following patchset is for
enabling dynamic change of cache setting for block devices
through qemu monitor. Code changes are based on patches
from Christoph Hellwig and Prerna Saxena.
This patchset introduces monitor command 'block_set_hostcache'
using which host pagecache setting for a block device can be
changed dynamically. This patchset also introduces 'hostcache',
a new option for setting host cache from qemu command line.
Note: 'Hostcache and 'cache' options cannot be used
simultaneously from commandline.
v6:
1. "block_set_hostcache" to replace "block_set" command
v5:
1. Defined qerror class for incorrect command syntax.
2. Changed error_report() calls to qerror_report()
v4:
Added 'hostcache' option to '-drive' commandline option.
v3:
1. Command "block_set" for changing various block params
2. Enhanced info-block to display hostcache setting
3. Added qmp interfaces for setting and querying hostcache
v2:
1. Support of dynamic cache change only for hostcache.
2. Monitor command "hostcache_get" added to display cache setting
3. Backed off the changes for display of cache setting in "info block"
v1:
Dynamic cache change through monitor
New block command added:
"block_set_hostcache"
-- Sets hostcache parameter for block device while guest is running.
Usage:
block_set_hostcache <device> <option>
<device> = block device
<option> = on/off
New 'hostcache' option added to -drive:
-drive [file=file][,if=type][,bus=n][,unit=m][,media=d][,index=i]\n"
....
" [,readonly=on|off][,hostcache=on|off]\n"
1/4 Enhance "info block" to display hostcache setting
2/4 New qerrors for file reopen and data sync
3/4 Command "block_set_hostcache" for changing hostcache setting
4/4 'hostcache' option added to -drive in qemu commandline
qemu/block.c | 75 +++++++++++++++++++++++++++++++++++++++++++++++++++
qemu/block.h | 2 +
qemu/blockdev.c | 39 ++++++++++++++++++++++++
qemu/blockdev.h | 2 +
qemu/hmp-commands.hx | 14 +++++++++++++
qemu/qemu-config.c | 4 +++
qemu/qemu-options.hx | 2 -
qemu/qerror.c | 8 +++++++
qemu/qerror.h | 6 +++++
qemu/qmp-commands.hx | 29 +++++++++++++++++++++++++
10 files changed, 176 insertions(+), 5 deletions(-)
~
- [Qemu-devel] [v6 Patch 0/4]Qemu: Set host pagecache from cmdline and monitor,
Supriya Kannery <=