[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] Unable to enable +x2apic for the guest cpus...
From: |
Gleb Natapov |
Subject: |
Re: [Qemu-devel] Unable to enable +x2apic for the guest cpus... |
Date: |
Sat, 13 Oct 2012 09:32:09 +0200 |
On Fri, Oct 12, 2012 at 07:38:42PM -0700, Chegu Vinod wrote:
> Hello,
>
> I am using a very recent upstream version of qemu.git along with
> kvm.git kernels (in the host and guest).
> [Guest kernel had been compiled with CONFIG_X86_X2APIC and
> CONFIG_IRQ_REMAP both set]
>
> When I attempt to start a guest with +x2apic flag (pl. see the qemu
> cmd line below) I end up with a hang of the qemu and
> a kernel BUG at /arch/x86/kvm/lapic.c:159 ! Pl. see the attached
> screen shot of the console for additional info.
>
> I am able to boot the same guest without the +x2apic flag in the
> qemu cmd line.
>
> Not sure if this an issue (or) if I have something incorrectly
> specified in the qemu cmd line ? If its the latter...pl. advise the
> correct usage
> for enabling x2apic for the guest cpus.. for the upstream bits.
>
This is the bug in how ldr in x2apic mode is calculated.
Try the following patch:
diff --git a/arch/x86/kvm/lapic.c b/arch/x86/kvm/lapic.c
index c6e6b72..43e9fad 100644
--- a/arch/x86/kvm/lapic.c
+++ b/arch/x86/kvm/lapic.c
@@ -1311,7 +1311,7 @@ void kvm_lapic_set_base(struct kvm_vcpu *vcpu, u64 value)
vcpu->arch.apic_base = value;
if (apic_x2apic_mode(apic)) {
u32 id = kvm_apic_id(apic);
- u32 ldr = ((id & ~0xf) << 16) | (1 << (id & 0xf));
+ u32 ldr = ((id >> 4) << 16) | (1 << (id & 0xf));
kvm_apic_set_ldr(apic, ldr);
}
apic->base_address = apic->vcpu->arch.apic_base &
--
Gleb.