[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] [PATCH 1/5] ide: Reset BMIDEA bit when the bus master is st

From: Kevin Wolf
Subject: [Qemu-devel] [PATCH 1/5] ide: Reset BMIDEA bit when the bus master is stopped
Date: Wed, 8 May 2013 11:43:22 +0200

The device is supposed to reset the Bus Master IDE Active bit in the
status register when 0 is written to the Start/Stop Bus Master bit in
the command register.

In the common cases this happens automatically because bdrv_drain_all()
flushes the requests, but with a large PRDT it could remain set.

Signed-off-by: Kevin Wolf <address@hidden>
 hw/ide/pci.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/hw/ide/pci.c b/hw/ide/pci.c
index a310975..635a364 100644
--- a/hw/ide/pci.c
+++ b/hw/ide/pci.c
@@ -312,6 +312,7 @@ void bmdma_cmd_writeb(BMDMAState *bm, uint32_t val)
                 assert(bm->bus->dma->aiocb == NULL);
+            bm->status &= ~BM_STATUS_DMAING;
         } else {
             bm->cur_addr = bm->addr;
             if (!(bm->status & BM_STATUS_DMAING)) {

reply via email to

[Prev in Thread] Current Thread [Next in Thread]