qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] [PULL v2 04/11] i8259: don't abort when trying to use level


From: Michael S. Tsirkin
Subject: [Qemu-devel] [PULL v2 04/11] i8259: don't abort when trying to use level sensitive irqs
Date: Wed, 7 May 2014 19:17:01 +0300

From: Hervé Poussineau <address@hidden>

This is a guest-triggerable error, as seen when using Xenix 2.3.4.
Replace hw_error by LOG_UNIMPL, so that guests can continue.
With this patch, I can install and use Xenix 2.3.4a without any problem.
I can also start installation of Xenix 2.3.4q, but it fails due to not
finding an hard disk.

Signed-off-by: Hervé Poussineau <address@hidden>
Acked-by: Michael S. Tsirkin <address@hidden>
Signed-off-by: Michael S. Tsirkin <address@hidden>
---
 hw/intc/i8259.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/hw/intc/i8259.c b/hw/intc/i8259.c
index c6f248b..a069d04 100644
--- a/hw/intc/i8259.c
+++ b/hw/intc/i8259.c
@@ -265,7 +265,8 @@ static void pic_ioport_write(void *opaque, hwaddr addr64,
             s->init4 = val & 1;
             s->single_mode = val & 2;
             if (val & 0x08) {
-                hw_error("level sensitive irq not supported");
+                qemu_log_mask(LOG_UNIMP,
+                              "i8259: level sensitive irq not supported\n");
             }
         } else if (val & 0x08) {
             if (val & 0x04) {
-- 
MST




reply via email to

[Prev in Thread] Current Thread [Next in Thread]