[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [PATCH v3 0/3] Add ASPEED SCU device

From: Peter Maydell
Subject: Re: [Qemu-devel] [PATCH v3 0/3] Add ASPEED SCU device
Date: Mon, 27 Jun 2016 14:47:07 +0100

On 24 June 2016 at 05:58, Andrew Jeffery <address@hidden> wrote:
> Hi all,
> These are three patches implementing minimal functionality for the ASPEED 
> System
> Control Unit device and integrating it into the AST2400 SoC model/palmetto-bmc
> machine. The device is critical for initialisation of u-boot and the kernel as
> it provides chip level control registers, influencing the configuration of the
> software and the software's configuration of the SoC.
> Since v2:
> * Fix mixing of offsets and register indexes
> * Sanity check device property values
> * SoC actually initialises the silicon revision
> Since v1:
> * Select reset values based on silicon revision
> * Expose hardware strapping values via properties
> Andrew Jeffery (3):
>   hw/misc: Add a model for the ASPEED System Control Unit
>   ast2400: Integrate the SCU model and set silicon revision
>   palmetto-bmc: Configure the SCU's hardware strapping register

Applied to target-arm.next, thanks.

-- PMM

reply via email to

[Prev in Thread] Current Thread [Next in Thread]