Re: [Qemu-devel] [PATCH] migration: introduce decompress-error-check

[Xiao Guangrong]

On 04/27/2018 05:31 PM, Peter Xu wrote:
> On Fri, Apr 27, 2018 at 11:15:37AM +0800, Xiao Guangrong wrote:
> > On 04/26/2018 10:01 PM, Eric Blake wrote:
> > > On 04/26/2018 04:15 AM, address@hidden wrote:
> > > > From: Xiao Guangrong <address@hidden>
> > > >
> > > > QEMU 2.13 enables strict check for compression & decompression to
> > > > make the migration more robuster, that depends on the source to fix
> > >
> > > s/robuster/robust/
> >
> > Will fix, thank you for pointing it out.
> >
> > > > the internal design which triggers the unexpected error conditions
> > >
> > > 2.13 hasn't been released yet.  Why do we need a knob to explicitly turn
> > > off strict checking?  Can we not instead make 2.13 automatically smart
> > > enough to tell if the incoming stream is coming from an older qemu
> > > (which might fail if the strict checks are enabled) vs. a newer qemu
> > > (the sender gave us what we need to ensure the strict checks are
> > > worthwhile)?
> >
> > Really smart.
> >
> > How about introduce a new command, MIG_CMD_DECOMPRESS_ERR_CHECK,
> > the destination will do strict check if got this command (i.e, new
> > QEMU is running on the source), otherwise, turn the check off.
>
> Why not we just introduce a compat bit for that?  I mean something
> like: 15c3850325 ("migration: move skip_section_footers",
> 2017-06-28).  Then we turn that check bit off for <=2.12.
>
> Would that work?

I am afraid it can not. :(

The compat bit only impacts local behavior, however, in this case, we
need the source QEMU to tell the destination if it supports strict
error check.