[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [PATCH v1 1/1] configure: Add RISC-V host support

From: Richard Henderson
Subject: Re: [Qemu-devel] [PATCH v1 1/1] configure: Add RISC-V host support
Date: Sat, 28 Jul 2018 09:36:30 -0700
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:52.0) Gecko/20100101 Thunderbird/52.9.1

On 07/27/2018 04:49 PM, Alistair Francis wrote:
> Allow QEMU to be built to run on a RISC-V host.
> QEMU does not yet have a RISC-V TCG or user mode target port, but
> running other architectures on RISC-V using TCI does work.
> Signed-off-by: Alistair Francis <address@hidden>
> ---
>  configure | 18 +++++++++++++++++-
>  1 file changed, 17 insertions(+), 1 deletion(-)

This is ok as far as it goes.

Even for TCI, you need some more.

At minimum, see Michael Clark's branch changes to accel/tcg/user-exec.c for
host signal handling.  While you can run *-softmmu without this, none of
*-linux-user will work reliably.

Another piece that even Michael Clark does not have is


reply via email to

[Prev in Thread] Current Thread [Next in Thread]