[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH] RISC-V - Dynamic parameterization of RISC-V mem
Re: [Qemu-devel] [PATCH] RISC-V - Dynamic parameterization of RISC-V memory map
Thu, 6 Sep 2018 08:07:25 -0700
Mozilla/5.0 (X11; Linux x86_64; rv:52.0) Gecko/20100101 Thunderbird/52.9.1
On 08/30/2018 09:22 AM, Michael Eager wrote:
Corrected patch attached.
On 08/29/2018 05:48 PM, Michael Eager wrote:
Whoops. I just noticed that this patch is against the riscv-qemu
repo on github, not the qemu.org repo. I will rework it for the
qemu.org repo. Meanwhile, I welcome any comments.
On 08/29/2018 05:21 PM, Michael Eager wrote:
Memory parameters for RISC-V boards can be read from a configuration
file using the -readconfig command line option. The configuration file
should have a section for the board and memory. The configuration for
the VirtIO board has the following configuration variables:
debug-base = "0x0"
debug-size = "0x100"
mrom-base = "0x1000"
mrom-size = "0x11000"
test-base = "0x100000"
test-size = "0x1000"
clint-base = "0x2000000"
clint-size = "0x10000"
plic-base = "0xc000000"
plic-size = "0x4000000"
uart0-base = "0x10000000"
uart0-size = "0x100"
virtio-base = "0x10001000"
virtio-size = "0x1000"
dram-base = "0x80000000"
dram-size = "0x0"
Values must be enclosed within quotes.
Signed-off-by: Michael Eager <address@hidden>
Michael Eager address@hidden
1960 Park Blvd., Palo Alto, CA 94306
- Re: [Qemu-devel] [PATCH] RISC-V - Dynamic parameterization of RISC-V memory map,
Michael Eager <=