Re: [Qemu-devel] unknown keycodes `(unnamed)', please report to address@hidden

[Daniel P . Berrangé]

On Thu, Jan 24, 2019 at 08:34:50AM +0000, Burgess, Alison E wrote:
> I am running Ubuntu 18.04 and I am sending this email because when
> I try to run these series of commands in an executable file in
> 
> 
> arm-none-eabi-as -mcpu=arm926ej-s -g ts.s -o ts.o
> arm-none-eabi-gcc -c -mcpu=arm926ej-s -g t.c -o t.o
> arm-none-eabi-ld -T t.ld ts.o t.o -o t.elf
> arm-none-eabi-objcopy -O binary t.elf t.bin
> arm-none-eabi-readelf -a t.elf
> 
> rm *.o *.elf
> 
> echo ready to go?
> read dummy
> 
> qemu-system-arm -M realview-pbx-a9 -m 128M -kernel t.bin \
> -serial mon:stdio -serial /dev/pts/0 -serial /dev/pts/0 -serial /dev/pts/0
> 
> (where the number in /dev/pts/# is the number I get when I run ps in the 
> terminal)
> 
> The qemu terminal appears, but once I press 'Enter' again so that
> my code runs, I am faced with the unknown keycodes `(unnamed)',
> please report to address@hidden error message. After a couple
> of hours searching online I have not been able to find a solution
> and I have download and reinstalled qemu a couple of times.

Can you tell us what version of QEMU you are using ?  In addition what
environment are you running it under ?  X11 or Wayland or something
else ?  Finally, what keyboard layout is your environment setup to use ?


Regards,
Daniel
-- 
|: https://berrange.com      -o-    https://www.flickr.com/photos/dberrange :|
|: https://libvirt.org         -o-            https://fstop138.berrange.com :|
|: https://entangle-photo.org    -o-    https://www.instagram.com/dberrange :|