[Qemu-devel] [PULL 3/5] xhci: Add No Op Command

[Gerd Hoffmann]

From: Hikaru Nishida <address@hidden>

This commit adds No Op Command (23) to xHC for verifying the operation
of the Command Ring mechanisms.
No Op Command is defined in XHCI spec (4.6.2) and just reports Command
Completion Event with Completion Code == Success.
Before this commit, No Op Command is not implemented so xHC reports
Command Completion Event with Completion Code == TRB Error. This commit
fixes this behaviour to report Completion Code correctly.

Signed-off-by: Hikaru Nishida <address@hidden>
Message-id: address@hidden
Signed-off-by: Gerd Hoffmann <address@hidden>
---
 hw/usb/hcd-xhci.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/hw/usb/hcd-xhci.c b/hw/usb/hcd-xhci.c
index f698224c8a06..f5782649482b 100644
--- a/hw/usb/hcd-xhci.c
+++ b/hw/usb/hcd-xhci.c
@@ -2543,6 +2543,9 @@ static void xhci_process_commands(XHCIState *xhci)
         case CR_GET_PORT_BANDWIDTH:
             event.ccode = xhci_get_port_bandwidth(xhci, trb.parameter);
             break;
+        case CR_NOOP:
+            event.ccode = CC_SUCCESS;
+            break;
         case CR_VENDOR_NEC_FIRMWARE_REVISION:
             if (xhci->nec_quirks) {
                 event.type = 48; /* NEC reply */
-- 
2.18.1