[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[PULL 1/1] audio: add -audiodev pa,in|out.latency= to documentation
From: |
Gerd Hoffmann |
Subject: |
[PULL 1/1] audio: add -audiodev pa,in|out.latency= to documentation |
Date: |
Wed, 6 Nov 2019 09:26:04 +0100 |
From: Stefan Hajnoczi <address@hidden>
The "latency" parameter wasn't covered by the documentation.
Signed-off-by: Stefan Hajnoczi <address@hidden>
Reviewed-by: Marc-André Lureau <address@hidden>
Message-id: address@hidden
Signed-off-by: Gerd Hoffmann <address@hidden>
---
qemu-options.hx | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/qemu-options.hx b/qemu-options.hx
index 1fc2470e2fd4..ee4a099e252f 100644
--- a/qemu-options.hx
+++ b/qemu-options.hx
@@ -471,6 +471,7 @@ DEF("audiodev", HAS_ARG, QEMU_OPTION_audiodev,
"-audiodev pa,id=id[,prop[=value][,...]]\n"
" server= PulseAudio server address\n"
" in|out.name= source/sink device name\n"
+ " in|out.latency= desired latency in microseconds\n"
#endif
#ifdef CONFIG_AUDIO_SDL
"-audiodev sdl,id=id[,prop[=value][,...]]\n"
@@ -645,6 +646,10 @@ Sets the PulseAudio @var{server} to connect to.
@item in|out.name=@var{sink}
Use the specified source/sink for recording/playback.
+@item in|out.latency=@var{usecs}
+Desired latency in microseconds. The PulseAudio server will try to honor this
+value but actual latencies may be lower or higher.
+
@end table
@item -audiodev sdl,id=@var{id}[,@var{prop}[=@var{value}][,...]]
--
2.18.1