[PULL 17/18] hw/arm/raspi: Use RaspiProcessorId to set the firmware load address

[Peter Maydell]

From: Philippe Mathieu-Daudé <f4bug@amsat.org>

The firmware load address depends on the SoC ("processor id") used,
not on the version of the board.

Suggested-by: Luc Michel <luc.michel@greensocs.com>
Reviewed-by: Luc Michel <luc.michel@greensocs.com>
Signed-off-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Message-id: 20200924111808.77168-8-f4bug@amsat.org
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 hw/arm/raspi.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/hw/arm/raspi.c b/hw/arm/raspi.c
index 0d8e5a34c78..ae98a2fbfca 100644
--- a/hw/arm/raspi.c
+++ b/hw/arm/raspi.c
@@ -238,7 +238,8 @@ static void setup_boot(MachineState *machine, int version, 
size_t ram_size)
      * the normal Linux boot process
      */
     if (machine->firmware) {
-        hwaddr firmware_addr = version == 3 ? FIRMWARE_ADDR_3 : 
FIRMWARE_ADDR_2;
+        hwaddr firmware_addr = processor_id <= PROCESSOR_ID_BCM2836
+                             ? FIRMWARE_ADDR_2 : FIRMWARE_ADDR_3;
         /* load the firmware image (typically kernel.img) */
         r = load_image_targphys(machine->firmware, firmware_addr,
                                 ram_size - firmware_addr);
-- 
2.20.1