[PATCH v8 02/10] hw/ssi: imx_spi: Remove imx_spi_update_irq() in imx_spi_reset()

[Bin Meng]

From: Bin Meng <bin.meng@windriver.com>

Usually the approach is that the device on the other end of the line
is going to reset its state anyway, so there's no need to actively
signal an irq line change during the reset hook.

Move imx_spi_update_irq() out of imx_spi_reset(), to a new function
imx_spi_soft_reset() that is called when the controller is disabled.

Signed-off-by: Bin Meng <bin.meng@windriver.com>

---

(no changes since v5)

Changes in v5:
- rename imx_spi_hard_reset() to imx_spi_soft_reset()

Changes in v4:
- adujst the patch 2,3 order
- rename imx_spi_soft_reset() to imx_spi_hard_reset() to avoid confusion

Changes in v3:
- new patch: remove imx_spi_update_irq() in imx_spi_reset()

 hw/ssi/imx_spi.c | 14 ++++++++++----
 1 file changed, 10 insertions(+), 4 deletions(-)

diff --git a/hw/ssi/imx_spi.c b/hw/ssi/imx_spi.c
index e605049..4d488b1 100644
--- a/hw/ssi/imx_spi.c
+++ b/hw/ssi/imx_spi.c
@@ -241,11 +241,16 @@ static void imx_spi_reset(DeviceState *dev)
     imx_spi_rxfifo_reset(s);
     imx_spi_txfifo_reset(s);
 
-    imx_spi_update_irq(s);
-
     s->burst_length = 0;
 }
 
+static void imx_spi_soft_reset(IMXSPIState *s)
+{
+    imx_spi_reset(DEVICE(s));
+
+    imx_spi_update_irq(s);
+}
+
 static uint64_t imx_spi_read(void *opaque, hwaddr offset, unsigned size)
 {
     uint32_t value = 0;
@@ -351,8 +356,9 @@ static void imx_spi_write(void *opaque, hwaddr offset, 
uint64_t value,
         s->regs[ECSPI_CONREG] = value;
 
         if (!imx_spi_is_enabled(s)) {
-            /* device is disabled, so this is a reset */
-            imx_spi_reset(DEVICE(s));
+            /* device is disabled, so this is a soft reset */
+            imx_spi_soft_reset(s);
+
             return;
         }
 
-- 
2.7.4