[PATCH v3 10/10] esp: recreate ESPState current_req after migration

[Mark Cave-Ayland]

Since PDMA reads/writes are driven by the guest, it is possible that migration
can occur whilst a SCSIRequest is still active. Fortunately active SCSIRequests
are already included in the migration stream and restarted post migration but
this still leaves the reference in ESPState uninitialised.

Implement the SCSIBusInfo .load_request callback to obtain a reference to the
currently active SCSIRequest and use it to recreate ESPState current_req
after migration.

Suggested-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>
Reviewed-by: Laurent Vivier <laurent@vivier.eu>
---
 hw/scsi/esp.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/hw/scsi/esp.c b/hw/scsi/esp.c
index 3f7cf30fa7..2d3c649567 100644
--- a/hw/scsi/esp.c
+++ b/hw/scsi/esp.c
@@ -1349,6 +1349,15 @@ static uint64_t sysbus_esp_pdma_read(void *opaque, 
hwaddr addr,
     return val;
 }
 
+static void *esp_load_request(QEMUFile *f, SCSIRequest *req)
+{
+    ESPState *s = container_of(req->bus, ESPState, bus);
+
+    scsi_req_ref(req);
+    s->current_req = req;
+    return s;
+}
+
 static const MemoryRegionOps sysbus_esp_pdma_ops = {
     .read = sysbus_esp_pdma_read,
     .write = sysbus_esp_pdma_write,
@@ -1364,6 +1373,7 @@ static const struct SCSIBusInfo esp_scsi_info = {
     .max_target = ESP_MAX_DEVS,
     .max_lun = 7,
 
+    .load_request = esp_load_request,
     .transfer_data = esp_transfer_data,
     .complete = esp_command_complete,
     .cancel = esp_request_cancelled
-- 
2.20.1