[PATCH] tulip: Assign default MAC address if not specified

[Helge Deller]

The MAC of the tulip card is stored in the EEPROM and at startup
tulip_fill_eeprom() is called to initialize the EEPROM with the MAC
address given on the command line, e.g.:
    -device tulip,mac=00:11:22:33:44:55

In case the mac address was not given on the command line,
tulip_fill_eeprom() initializes the MAC in EEPROM with 00:00:00:00:00:00
which breaks e.g. a HP-UX guest.

Fix this problem by moving qemu_macaddr_default_if_unset() a few lines
up, so that a default mac address is assigned before tulip_fill_eeprom()
initializes the EEPROM.

Signed-off-by: Helge Deller <deller@gmx.de>

diff --git a/hw/net/tulip.c b/hw/net/tulip.c
index d5b6cc5ee6..097e905bec 100644
--- a/hw/net/tulip.c
+++ b/hw/net/tulip.c
@@ -967,6 +967,8 @@ static void pci_tulip_realize(PCIDevice *pci_dev, Error 
**errp)
     pci_conf = s->dev.config;
     pci_conf[PCI_INTERRUPT_PIN] = 1; /* interrupt pin A */

+    qemu_macaddr_default_if_unset(&s->c.macaddr);
+
     s->eeprom = eeprom93xx_new(&pci_dev->qdev, 64);
     tulip_fill_eeprom(s);

@@ -981,8 +983,6 @@ static void pci_tulip_realize(PCIDevice *pci_dev, Error 
**errp)

     s->irq = pci_allocate_irq(&s->dev);

-    qemu_macaddr_default_if_unset(&s->c.macaddr);
-
     s->nic = qemu_new_nic(&net_tulip_info, &s->c,
                           object_get_typename(OBJECT(pci_dev)),
                           pci_dev->qdev.id, s);