For M-profile, the fault address is not always exposed to the guest
in a fault register (for instance the BFAR bus fault address register
is only updated for bus faults on data accesses, not instruction
accesses). Currently we log the address only if we're putting it
into a particular guest-visible register. Since we always have it,
log it generically, to make logs of i-side faults a bit clearer.
Signed-off-by: Peter Maydell<peter.maydell@linaro.org>
---
target/arm/m_helper.c | 6 ++++++
1 file changed, 6 insertions(+)