[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH v3 0/2] target/riscv: Allow software access to MIP SEIP
From: |
Alistair Francis |
Subject: |
Re: [PATCH v3 0/2] target/riscv: Allow software access to MIP SEIP |
Date: |
Fri, 18 Mar 2022 09:13:51 +1000 |
On Thu, Mar 17, 2022 at 4:18 PM Alistair Francis
<alistair.francis@opensource.wdc.com> wrote:
>
> From: Alistair Francis <alistair.francis@wdc.com>
>
> The RISC-V specification states that:
> "Supervisor-level external interrupts are made pending based on the
> logical-OR of the software-writable SEIP bit and the signal from the
> external interrupt controller."
>
> We currently only allow either the interrupt controller or software to
> set the bit, which is incorrect.
>
> This patch removes the miclaim mask when writing MIP to allow M-mode
> software to inject interrupts, even with an interrupt controller.
>
> We then also need to keep track of which source is setting MIP_SEIP. The
> final value is a OR of both, so we add two bools and use that to keep
> track of the current state. This way either source can change without
> losing the correct value.
>
> This fixes: https://gitlab.com/qemu-project/qemu/-/issues/904
>
> Alistair Francis (2):
> target/riscv: cpu: Fixup indentation
> target/riscv: Allow software access to MIP SEIP
Thanks!
Applied to riscv-to-apply.next
Alistair
>
> target/riscv/cpu.h | 8 ++++++++
> target/riscv/cpu.c | 30 +++++++++++++++++++-----------
> target/riscv/csr.c | 8 ++++++--
> 3 files changed, 33 insertions(+), 13 deletions(-)
>
> --
> 2.35.1
>