qemu-ppc
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-ppc] [PATCH v3 06/24] target-ppc: Enable writes to user-privil


From: Alexey Kardashevskiy
Subject: Re: [Qemu-ppc] [PATCH v3 06/24] target-ppc: Enable writes to user-privileged PMU registers
Date: Wed, 28 May 2014 12:28:02 +1000
User-agent: Mozilla/5.0 (X11; Linux i686 on x86_64; rv:24.0) Gecko/20100101 Thunderbird/24.5.0

On 05/28/2014 10:03 AM, Alexander Graf wrote:
> 
> On 27.05.14 12:37, Alexey Kardashevskiy wrote:
>> This adds spr_write_ureg() helper and uses it for UPMCx and MMCR0 SPRs.
>>
>> Signed-off-by: Alexey Kardashevskiy <address@hidden>
>> ---
>>   target-ppc/translate_init.c | 25 +++++++++++++++----------
>>   1 file changed, 15 insertions(+), 10 deletions(-)
>>
>> diff --git a/target-ppc/translate_init.c b/target-ppc/translate_init.c
>> index 88acf70..595fd3f 100644
>> --- a/target-ppc/translate_init.c
>> +++ b/target-ppc/translate_init.c
>> @@ -175,6 +175,11 @@ static void spr_read_ureg (void *opaque, int gprn,
>> int sprn)
>>       gen_load_spr(cpu_gpr[gprn], sprn + 0x10);
>>   }
>>   +static void spr_write_ureg(void *opaque, int gprn, int sprn)
>> +{
>> +    gen_store_spr(sprn + 0x10, cpu_gpr[gprn]);
>> +}
>> +
>>   /* SPR common to all non-embedded PowerPC */
>>   /* DECR */
>>   #if !defined(CONFIG_USER_ONLY)
>> @@ -7379,28 +7384,28 @@ static void gen_spr_book3s_pmu(CPUPPCState *env)
>>                    &spr_read_generic, SPR_NOACCESS,
>>                    0x00000000);
>>       spr_register(env, SPR_POWER_UMMCR0, "UMMCR0",
>> -                 &spr_read_ureg, SPR_NOACCESS,
>> -                 &spr_read_ureg, SPR_NOACCESS,
>> +                 &spr_read_ureg, &spr_write_ureg,
>> +                 &spr_read_ureg, &spr_write_ureg,
> 
> Are you sure about this? The 970MP spec says "Performance Monitor Registers
> (For Reading)". In general, I don't think we would ever really have an
> spr_write_ureg user.

Uffff. It is worse than that. They were read-only for user space till 2.07,
now they might be write-enabled too because of EBB. Do I really have to
implement exceptions on accessing them as described in "6.2.11 Hypervisor
Facility Status and Control Register" (2.07)? It is getting too much just
to get H_SET_MODE(AIL) accepted, no? :-)



-- 
Alexey



reply via email to

[Prev in Thread] Current Thread [Next in Thread]