[PULL 09/33] spapr/xive: Use kvmppc_xive_source_reset() in post_load

[David Gibson]

From: Cédric Le Goater <clg@kaod.org>

This is doing an extra loop but should be equivalent.

It also differentiate the reset of the sources from the restore of the
sources configuration. This will help in allocating the vCPU IPIs
independently.

Signed-off-by: Cédric Le Goater <clg@kaod.org>
Message-Id: <20200820134547.2355743-3-clg@kaod.org>
Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
---
 hw/intc/spapr_xive_kvm.c | 20 ++++++++++----------
 1 file changed, 10 insertions(+), 10 deletions(-)

diff --git a/hw/intc/spapr_xive_kvm.c b/hw/intc/spapr_xive_kvm.c
index 0e834b4b71..3e80ea0ce9 100644
--- a/hw/intc/spapr_xive_kvm.c
+++ b/hw/intc/spapr_xive_kvm.c
@@ -646,22 +646,22 @@ int kvmppc_xive_post_load(SpaprXive *xive, int version_id)
         }
     }
 
+    /*
+     * We can only restore the source config if the source has been
+     * previously set in KVM. Since we don't do that at reset time
+     * when restoring a VM, let's do it now.
+     */
+    ret = kvmppc_xive_source_reset(&xive->source, &local_err);
+    if (ret < 0) {
+        goto fail;
+    }
+
     /* Restore the EAT */
     for (i = 0; i < xive->nr_irqs; i++) {
         if (!xive_eas_is_valid(&xive->eat[i])) {
             continue;
         }
 
-        /*
-         * We can only restore the source config if the source has been
-         * previously set in KVM. Since we don't do that for all interrupts
-         * at reset time anymore, let's do it now.
-         */
-        ret = kvmppc_xive_source_reset_one(&xive->source, i, &local_err);
-        if (ret < 0) {
-            goto fail;
-        }
-
         ret = kvmppc_xive_set_source_config(xive, i, &xive->eat[i], 
&local_err);
         if (ret < 0) {
             goto fail;
-- 
2.26.2