qemu-ppc
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [PATCH 4/6] target/ppc: Alignment faults do not set DSISR in ISA v3.


From: Nicholas Piggin
Subject: Re: [PATCH 4/6] target/ppc: Alignment faults do not set DSISR in ISA v3.0 onward
Date: Mon, 27 Mar 2023 14:26:42 +1000

On Fri Mar 24, 2023 at 11:39 PM AEST, Fabiano Rosas wrote:
> Nicholas Piggin <npiggin@gmail.com> writes:
>
> > This optional behavior was removed from the ISA in v3.0, see
> > Summary of Changes preface:
> >
> >   Data Storage Interrupt Status Register for Alignment Interrupt:
> >   Simplifies the Alignment interrupt by remov- ing the Data Storage
> >   Interrupt Status Register (DSISR) from the set of registers modified
> >   by the Alignment interrupt.
> >
> > Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
> > ---
> >  target/ppc/excp_helper.c | 23 ++++++++++++++++-------
> >  1 file changed, 16 insertions(+), 7 deletions(-)
> >
> > diff --git a/target/ppc/excp_helper.c b/target/ppc/excp_helper.c
> > index 5f0e363363..c8b8eca3b1 100644
> > --- a/target/ppc/excp_helper.c
> > +++ b/target/ppc/excp_helper.c
> > @@ -1456,13 +1456,22 @@ static void powerpc_excp_books(PowerPCCPU *cpu, int 
> > excp)
> >          break;
> >      }
> >      case POWERPC_EXCP_ALIGN:     /* Alignment exception                    
> >   */
> > -        /* Get rS/rD and rA from faulting opcode */
> > -        /*
> > -         * Note: the opcode fields will not be set properly for a
> > -         * direct store load/store, but nobody cares as nobody
> > -         * actually uses direct store segments.
> > -         */
> > -        env->spr[SPR_DSISR] |= (env->error_code & 0x03FF0000) >> 16;
> > +        switch (env->excp_model) {
>
> Slightly better would be to check on (env->insn_flags2 & PPC2_ISA300).
> We were trying to phase out the usage of "exception models" wherever
> possible in favor of specific feature/isa level flags.

Oh good point, thanks for catching that. Will fix and resend the series
(I've done the same thing in a few other places too).

Thanks,
Nick



reply via email to

[Prev in Thread] Current Thread [Next in Thread]