[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Screen stops attached process in copy mode

From: Rogers Colin M
Subject: Screen stops attached process in copy mode
Date: Fri, 30 Jun 2006 12:10:58 +0100

I'm running a program in that produces significant amounts of terminal output. I start this program in a detached screen, and at some point later attach it. This presents me with a view of the output from the program, which is fine.


However, if I then enter copy mode, a short while later the program stops execution, and only resumes when I leave copy mode. This is very irritating as the program is time dependent, and so stopping it running causes problems.


I can't find anything about this in the manual, so can anyone tell me if this is the intended behaviour, and whether I can get around it in anyway (i.e. allow the program to keep outputting to the "terminal" when in copy mode?)



The information contained in this E-Mail and any subsequent
correspondence is private and is intended solely for the intended
recipient(s).  The information in this communication may be confidential
and/or legally privileged.  Nothing in this e-mail is intended to
conclude a contract on behalf of QinetiQ or make QinetiQ subject to any
other legally binding commitments, unless the e-mail contains an express
statement to the contrary or incorporates a formal Purchase Order.

For those other than the recipient any disclosure, copying,
distribution, or any action taken or omitted to be taken in reliance on
such information is prohibited and may be unlawful.

Emails and other electronic communication with QinetiQ may be monitored
and recorded for business purposes including security, audit and
archival purposes.  Any response to this email indicates consent to

Telephone calls to QinetiQ may be monitored or recorded for quality
control, security and other business purposes.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]