Re: [Tlf-devel] Using TLF with hamlib

[Ed]

Bob Nielsen wrote:
> I tried the TS-570D with xlog and hamlib and had similar problems.
> Strangely, grig works for the most part (it talks to the radio but a few
> functions don't respond).  I'll see if I can figure out what is
> happening or ask on the hamlib list.  I'll also finish the I/O card for
> my K2 and give that a try.
> 
> Bob, N7XY
> 
> On Wed, 2005-05-04 at 12:13 +0200, Rein Couperus PA0R wrote:
> 
>>I have tlf-0.9.23 running without problem with hamblib 1.2.4 and the
>>ORION (rig nr. 1608). Also no problem with the K2.
>>
>>my config.h says:
>>
>>/* Define if you have the <hamlib/riglist.h> header file. */
>>/* #undef HAVE_HAMLIB_RIGLIST_H */
>>
>>/* Define if you have the <hamlib/rig.h> header file. */
>>#define HAVE_HAMLIB_RIG_H 1
>>
>>/* Define if you have the <inttypes.h> header file. */
>>#define HAVE_INTTYPES_H 1
>>
>>/* Define if you have the `hamlib' library (-lhamlib). */
>>#define HAVE_LIBHAMLIB 1
>>
>>Looks like tlf does not need riglist.h
>>
>>Moreover, the error message you get is not from tlf, but from hamlib, so
>>I would look in that direction...
>>
>>Anybody else have problems with the TS570D ?
>>
>>Rein PA0R
>>
>>
>>
>>
>>
>>On Mon, 2005-05-02 at 16:55 -0700, Bob Nielsen wrote:
>>
>>>I finally got around to trying to interface my TS-570D to my computer.  
>>>It works fine with grig, but I haven't been able to get the rig to talk 
>>>to TLF.
>>>
>>>I ran configure with --enable-hamlib.  It appears to recognize hamlib:
>>>
>>>checking for main in -lhamlib... yes
>>>checking hamlib/rig.h usability... yes
>>>checking hamlib/rig.h presence... yes
>>>checking for hamlib/rig.h... yes
>>>enabling hamlib support
>>>
>>>However, checking the resultant config.h, I see:
>>>
>>>
>>>/* Define if you have the <hamlib/riglist.h> header file. */
>>>/* #undef HAVE_HAMLIB_RIGLIST_H */
>>>
>>>However, /usr/include/hamlib/riglist.h exists.
>>>
>>>I compiled TLF and enabled rig control in logcfg.dat, setting RIGMODEL, 
>>>RIGSPEED and RIGPORT to the appropriate values.  When I run TLF, I get 
>>>the following:
>>>
>>>Trying to start rig ctrl
>>>rig_open: error
>>>
>>>Editing config.h to define HAVE_HAMLIB_RIGLIST_H doesn't help
>>>
>>>TLF is version 0.9.23 and hamlib-dev is version 1.2.4-1.  The system is
>>>a 1.2 GHz Celeron running Libranet 2.8.1 updated with packages from
>>>Debian Sarge and Sid.
>>>
>>>Any ideas?
>>>
>>>TIA and 73,
>>>
>>>Bob, N7XY


Bob, you do have hamlib-utils installed don't you. ??  I think you will
find it is needed for the apps you have installed. Not sure it is just a
Debian thing or not. TIA....73

Ed W3NR