[XForms] Bug in "fdesign" tool?

[Arie van Wettum]

Hi All,

I'm using  Xforms 1.2.2 and  encounter a strange behaviour using the "fdesign" tool creating a active XYplot.
What happens.
I make a new form, add a "NORMAL" xyplot, save this form and exit fdesign.
When I start fdesign again I can load the form and can continue working on the form.
However, when i choose for an "ACTIVE"  xyplot" and save, I can't load the form again and get a "segmentation fault" message!
Any Idea what could cause this problem?

With kind regards,

Arie van Wettum

-- 
Arie van Wettum, Electronics Engineer
Utrecht University - Faculty of Geosciences
Department of Earth Sciences, Budapestlaan 4, 3584 CD Utrecht
PO Box 80021, 3508 TA Utrecht The Netherlands
Tel     +31 (0)30 253 5159
Fax     +31 (0)30 253 2648
Email   address@hidden