[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Which-function-mode is turning itself off

From: Richard.G.Bielawski
Subject: RE: Which-function-mode is turning itself off
Date: Tue, 17 May 2005 10:49:28 -0500

  -----Original Message-----
  From: Richard Stallman [mailto:address@hidden
  Sent: Monday, May 16, 2005 11:38 PM
  To: address@hidden
  Cc: address@hidden
  Subject: Re: Which-function-mode is turning itself off
      Since installing this change the problem
      has not re-occurred.  I took the change out and it occurs
   This is quite puzzling.

You're telling me.  I spent over an hour trying to figure out how
that was possible before asking for suggestions on what next.
      When which-function-mode turns itself off the error which
      the code below implies will be reported is nowhere to be
      found in my *messages* buffer.  I.E.
      "Error in which-func-update: ..."
   What is the rest of the message? 

It's not there.  I wish I knew. 
But I spent a couple more hours.
I believe this is the original error triggering the other error.

* error("Error in which-func-update: %s" (error "This buffer cannot use 
  byte-code("???\"? [info which-func-mode -1 error "Error in 
which-func-update: %s"] 3)
  which-func-update-1(#<window 43 on *Occur-N50S*>)

This error is consistent with the symptoms.  
It typically turns itself off when I'm in an occur buffer.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]