RE: [AUCTeX] Refering to figures in \inputed files

[Andersson, Henrik]

> -----Original Message-----
> From: Ralf Angeli [mailto:address@hidden
> Sent: den 1 november 2005 12:05
> To: Andersson, Henrik
> Cc: address@hidden
> Subject: Re: [AUCTeX] Refering to figures in \inputed files
> 
> * Henrik Andersson (2005-11-01) writes:
> 
> > What do I have to do to be able to refer to labels in \inputed
documents?
> >
> > When I try C-c ) and an appropiate label type, I can only choose
from
> > the labels found in the main file.
> 
> Did you follow (info "(reftex)Multifile Documents")?
> 
> --
> Ralf

Yes, I did, since it seemed very logical. But no luck...

I have a main file "TeX-master" named identifytracer.tex and below is
the content of one of the inputted files

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
\begin{figure}
  \centering
  \includegraphics[width=\textwidth]{fig6}
  \caption[Sensitivity v.s. time]{The summarized sensitivity based on
$\delta^{msqr}_j$
      (Eq.~\ref{eq:msqr}) on the modeled tracer concentration in the
      pore-water reaches optimal values at different times. Shallow
      and deep refers to the two parameter sets in
      Table~\ref{tab:tracer-parameters}. All
      functions start at 3 hours, which is considered to be a minimum
      time to integrate irregular animal behavior \citep{forster99}.}
  \label{fig:senstimeseries}
\end{figure}

%%% Local Variables: 
%%% mode: latex
%%% TeX-master: "identifytracer.tex"
%%% End:
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

So, what did I miss?

- Henrik