Hi All, I am facing a small problem with my basic Tx-R daughter boards. I am trying to transmit and receive a simple Cosine waveform of 40 Mhz and Amp of 10 using GRC and trying to see the transmitted-received signal on to the oscilloscope While probing into the transmitter DBA connector, I can see the transmitted cosine waveform on to the scope, but when I connect the transmitter and receiver using a DBA to DBA connector (that is connecting the transmitter and receiver directly) and probe the receiver, I am not able to see the transmitted cosine wave, but instead I can see a 60 Hz wave which I guess is the supply voltage freq, which remains even if I turn off my GRC . I tried to provide a ground using the ground pin (GND) on my Rx daughter board and also by different means but still face the same problem.
Can anybody please help me to figure out
this small issue.
Thanks & Regards, Somya Ajmera
|