All,
When I connect my USRP N200 to a PC running Suse, run
ifconfig eth0 192.168.10.1 command, and then run command
uhd_usrp_probe --args="addr=192.168.10.2", I see the famous
error message:
LookupError: KeyError: No devices found for ----->
Empty Device Address
The weird fact is that I have 9 other USRP N200 radios
which get detected when I run the command uhd_usrp_probe
--args="addr=192.168.10.2" on the same PC (so it shouldn't
be a firewall issue).
For the problematic USRP N200 I have done the following:
ping 192.168.10.1 which is fine
ping 192.168.10.2 which shows the error message that
destination is unreachable
I have also used switch S2 to enter into safe mode, burn
the right binaries (3.4.4 from maint branch), power-cycle the
device but the problem persists.
Any ideas on what might be preventing the USRP N200 from
being identified by the host PC?