|
From: | sumitstop |
Subject: | Re: [Discuss-gnuradio] tunnel.py command not working. |
Date: | Wed, 27 Feb 2013 11:01:49 -0800 (PST) |
Tom what do you mean by using different Tx & Rx frequencies. Also recently I did following. I connected 2 usrp with a single PC and ran 2 instances of tunnel in it with 1 usrp for each. Made two virtual ethernet interfaces gr0 & gr1 also set two different ip addresses. And I was able to ping from one ip address to another. I also did ssh and scp. Now suddenly I am getting doubt that was that a wireless ping ?? Or was it just withing a system i.e ping between two virtual ethernet interfaces inside the system. If it was within the system then I might have made a wrong screen cast on this tunnel thing which I recently uploaded on my channel http://www.youtube.com/watch?v=CLvV2Q7vh-o PS : Video is a bit blurred but one can easily make out -- View this message in context: http://gnuradio.4.n7.nabble.com/tunnel-py-command-not-working-tp39857p39886.html Sent from the GnuRadio mailing list archive at Nabble.com.
[Prev in Thread] | Current Thread | [Next in Thread] |