[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [gpsd-dev] GR-701W hangs on Pi-3
From: |
Hal Murray |
Subject: |
Re: [gpsd-dev] GR-701W hangs on Pi-3 |
Date: |
Fri, 03 Jun 2016 00:02:08 -0700 |
address@hidden said:
>> I donât think the issue is that the board designers cut cost -
>>thereâs power regulation on the boards.
> I'm sure there is. But not a lot of it. Many are the reports of problems
> in the presence of wobbly power - I'd heard a few myself even before I
> started working with these boards.
The regulators on the Pi provide 3.3V. The Pi expects the 5V to be close to
5V.
I think the basic problem is that the USB specs allow a lot lower than 5V and
the Pi designers didn't leave room for that.
USB spec says:
All hubs and peripheral devices shall be able to provide configuration
information with as little
as 4.00 V at the device end of their B-series receptacle. Both low and
high-power devices need
to be operational with this minimum voltage.
Figure 11-5 shows the minimum allowable voltages. Note that under transient
conditions, the
supply at the device can drop to 3.67 V for a brief moment.
The 24 AWG is a step in the right direction but not good enough if you expect
5V.
--
These are my opinions. I hate spam.
- [gpsd-dev] GR-701W hangs on Pi-3, Hal Murray, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Hal Murray, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Oliver Jowett, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Eric S. Raymond, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Gary E. Miller, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Eric S. Raymond, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Frank Nicholas, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Gary E. Miller, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Eric S. Raymond, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3,
Hal Murray <=
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Frank Nicholas, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Eric S. Raymond, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Gary E. Miller, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Gary E. Miller, 2016/06/02
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Frank Nicholas, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Gary E. Miller, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Hal Murray, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Gary E. Miller, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Hal Murray, 2016/06/03
- Re: [gpsd-dev] GR-701W hangs on Pi-3, Gary E. Miller, 2016/06/03