[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Help-glpk] Re: How to avoid output when reading in an mps problem.
From: |
Enea Zaffanella |
Subject: |
[Help-glpk] Re: How to avoid output when reading in an mps problem. |
Date: |
Wed, 26 Sep 2007 17:23:19 +0400 |
Oh, I now saw an answer to a similar question mentioning a new function
introduced in glpk 4.17.
Am I correct if I assume that the problem I asked has no solution in
glpk 4.14 ?
Thanks,
Enea Zaffanella.
Enea Zaffanella wrote:
> Hello.
>
> I am using glpk 4.13.
> When I call lpx_read_mps to read in a problem in mps format, I get some
> output such as the following:
>
> lpx_read_mps: reading problem data from `adlittle.mps'...
> lpx_read_mps: problem ADLITTLE
> lpx_read_mps: 57 rows, 97 columns, 465 non-zeros
> lpx_read_mps: 335 cards were read
>
> Is there any way to avoid this output?
>
> In the manual I saw something like
> "Behavior of the routine lpx_read_mps depends on some control
> parameters (see Subsection 2.11.6, page 55)"
>
> In subsection 2.11.6 I found option LPX_K_MSGLEV.
> However, in order to set this, I need an already build LP problem,
> whereas function lpx_read_mps constructs a new LP problem.
>
> So my question is: is there a way to (programmatically) avoid/control
> the output above?
>
> Cheers,
> Enea Zaffanella.
>
- [Help-glpk] Re: How to avoid output when reading in an mps problem.,
Enea Zaffanella <=