[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [libredwg] Segmentation Fault
|
From: |
R. van Twisk |
|
Subject: |
Re: [libredwg] Segmentation Fault |
|
Date: |
Thu, 23 Jun 2011 06:33:22 -0500 |
On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote:
> Hello everyone,
> I am using libredwg.Whenever i used convert command like
> ./testSVG input.dwg > output.svg
> it gives following error
> "Segmentation fault"
David, what version of dwg is that?
I noticed that DWG version 2010 (I believe)
will always segfault.
THis was tested with a draftsight export.
Ries
>
>
> --
> http://davinder.in
> Dont hurt the web, use open standards
>
- [libredwg] Segmentation Fault, Davinder Kumar, 2011/06/23
- Re: [libredwg] Segmentation Fault,
R. van Twisk <=
- Re: [libredwg] Segmentation Fault, Davinder Kumar, 2011/06/23
- Re: [libredwg] Segmentation Fault, R. van Twisk, 2011/06/23
- Re: [libredwg] Segmentation Fault, Davinder Kumar, 2011/06/23
- Re: [libredwg] Segmentation Fault, Till Heuschmann, 2011/06/23
- Re: [libredwg] Segmentation Fault, .Org.Com, 2011/06/23
- Re: [libredwg] Segmentation Fault, Davinder Kumar, 2011/06/24
- Re: [libredwg] [GD 7233] Re: Segmentation Fault, .Org.Com, 2011/06/24
- Re: [libredwg] [GD 7233] Re: Segmentation Fault, Davinder Kumar, 2011/06/24
- Re: [libredwg] Segmentation Fault, Rodrigo Rodrigues da Silva, 2011/06/26
- Re: [libredwg] Segmentation Fault, .Org.Com, 2011/06/26