Re: git-cl command not found

[David Nalesnik]

On Thu, Nov 14, 2019 at 7:05 PM David Kastrup <address@hidden> wrote:
>
> David Nalesnik <address@hidden> writes:
>
> > Trying to get git-cl going I run into an interesting problem.  I've
> > installed LilyDev, so I should have git-cl.
> >
> > I update:
> > [dev@lilydev:lilypond-git]$ cd ~/git-cl/
> > [dev@lilydev:git-cl]$ git pull
> > remote: Enumerating objects: 4, done.
> > remote: Counting objects: 100% (4/4), done.
> > remote: Compressing objects: 100% (2/2), done.
> > remote: Total 4 (delta 2), reused 3 (delta 2), pack-reused 0
> > Unpacking objects: 100% (4/4), done.
> > From git://github.com/gperciva/git-cl
> >    9511426..1994c03  master     -> origin/master
> > Updating 9511426..1994c03
> > Fast-forward
> >  allura_issues.py | 15 ++++++++-------
> >  1 file changed, 8 insertions(+), 7 deletions(-)
> >
> >
> > Make sure ca-certificates is there:
> >
> > [dev@lilydev:~]$ apt --installed list | grep ca-certificates
> >
> > WARNING: apt does not have a stable CLI interface. Use with caution in 
> > scripts.
> >
> > ca-certificates/oldstable,oldstable,now 20161130+nmu1+deb9u1 all [installed]
> >
> > But then I can't use git-cl:
> >
> > [dev@lilydev:~]$ cd $LILYPOND_GIT
> > [dev@lilydev:lilypond-git]$ git-cl config
> > bash: git-cl: command not found
> >
> > --------
> > What am I doing wrong?
>
> It's not in your PATH ?
>
Ah yes.  Duh.  Didn't think to check b/c I figured this would just
work out of the box.

Thanks...