[lwip-devel] [bug #64145] ICMP reply error when using bridge

[daniel.yang]

URL:
  <https://savannah.nongnu.org/bugs/?64145>

                 Summary: ICMP reply error when using bridge
                   Group: lwIP - A Lightweight TCP/IP stack
               Submitter: ccnu
               Submitted: Thu 04 May 2023 06:55:34 AM UTC
                Category: IPv4
                Severity: 3 - Normal
              Item Group: Faulty Behaviour
                  Status: None
                 Privacy: Public
             Assigned to: None
             Open/Closed: Open
         Discussion Lock: Any
         Planned Release: None
            lwIP version: 2.1.3


    _______________________________________________________

Follow-up Comments:


-------------------------------------------------------
Date: Thu 04 May 2023 06:55:34 AM UTC By: daniel.yang <ccnu>
    when I use lwIP netif implementing an IEEE 802.1D MAC Bridge,I add two
portif eth0(192.168.1.6) and eth1(192.168.1.7),also I set address and mac to
bridge as host netif(192.168.1.5).
    But,when I ping host(192.168.1.5) from eth1(192.168.1.7),I get no
reply.Then I debuged and found the issue point at function
icmp_input(icmp.c#198) and bridgeif_send_to_port(bridgeif.c #257).
    In this case, icmp request from eth1(input pbuf->if_idx = netif->num +
1,here is 1,default is 0),but in function icmp_input,it reuse the input pbuf
rather than alloc new one,so this pbuf->if_idx = netif->num + 1 = 1.Then
function bridgeif_send_to_port use the pbuf->if_idx to prevent sending out to
rx port(if (netif_get_index(portif) != p->if_idx)),at this time,icmp reply
would never be forward to eth1,so icmp error.
    icmp replied success when I added statement(p->if_idx = 0) at icmp.c#248
before ip4_output_if.







    _______________________________________________________

Reply to this item at:

  <https://savannah.nongnu.org/bugs/?64145>

_______________________________________________
Message sent via Savannah
https://savannah.nongnu.org/