paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Booz power board current capacity.


From: antoine drouin
Subject: Re: [Paparazzi-devel] Booz power board current capacity.
Date: Mon, 14 Jun 2010 04:37:40 +0200

I think the 225W figure is the power dissipation rating - the
transistor itself is rated 80 amps
I use this board on my 6*12inch hexarotor. You might want to make sure
the coper traces are thick and if they are not, put some solder on
them.

Regards

Poine

On Mon, Jun 14, 2010 at 4:32 AM, Eric Parsonage <address@hidden> wrote:
> Angus,
> Thanks
> So no good for 4 x 100 watt motors then.
> Eric
>
> On 14/06/2010, at 8:32 AM, Angus Peart wrote:
>
> Eric,
> The MOSFET on the power board is a FDB8442, which has a max power rating of
> 254W.
> Hope that helps!
> Cheers,
> Angus
>
> On 14 June 2010 01:46, Eric Parsonage <address@hidden> wrote:
>>
>> Hi all
>>
>> Does anybody have an idea of how much current I can realistically expect
>> to put through the booz power board without failure ?
>>
>> Thanks
>>
>> Eric
>>
>>
>>
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
>> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>



reply via email to

[Prev in Thread] Current Thread [Next in Thread]