Re: [Paparazzi-devel] re: ir/actuators problem

[Felix Ruess]

When you have two paparazzi installations in different folders you
should make sure to set your environment variables correctly.

On Thu, Dec 16, 2010 at 5:25 PM, GARCIA ALVAREZ, ANA
<address@hidden> wrote:
> I was testing the PFD. First of all it was upside down. I had to change the
> ir-signs(which I don’t understand because they were ok in the previous
> software version). The attitude in the PFD was more or less ok, but the
> elevator didn’t move at any time, while the ailerons moved very little.
>
> In auto1 we could move the elevator via the RC control, but it didn’t move
> all alone.
>
> I don’t understand I only have problems with the new software and not the
> previous one. May it be because I have them two in the same laptop(different
> folders)?Or because I had an airspeed sensor connected with a mcu
> warning(the one which was corrected today)?
>
> (I could send the test log)
>
> Thanks
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>