On Thu, Jan 6, 2011 at 3:35 PM, Thomas Wuensche
<address@hidden> wrote:
Hi all,
In sw/airborne/mcu_periph/i2c.h I2C_TRANSACTION_QUEUE_LEN is set
to 8. With my octorotor I find that the last motor is not driven
with this setting, but works if I increase it to 10.
Based on the code I think that value has to be at least one slot
bigger than the number of simultaneously scheduled I2C commands.
Should we have that value configurable in the airframe definition?
Should we have some plausibility checks against number of motors?
Regards, Thomas
--
EMS Dr. Thomas Wuensche e.K.
Sonnenhang 3
85304 Ilmmuenster
HRA Neuburg a.d. Donau, HR-Nr. 70.106
Phone: +49-8441-490260
Fax : +49-8441-81860
http://www.ems-wuensche.com
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel