Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.9.2.13) Gecko/20101208 Thunderbird/3.1.7
Hi,
The 'entering log_xml' is a recent debug message left by Felix. I
guess we should remove it or make it more explicit. But it also
means that the function that open the log file is called properly. I
tried this morning with the latest code from git and it works fine.
Do you see any crashes of the server when it starts receiving data ?
You can also start the message program with option "-c ground" to
see messages send by the server. If it recognizes your aircraft, you
will have the NEW_AIRCRAFT message.
Gautier
On 26/01/2011 10:32, Helge Walle wrote:
No, the simulation works fine. But in simulation I suppose it
is normal that a logfile is not created.
With my airplane setup the logfile is created, but stays on
with 0 data in it.
I tried with two different hardware sets and two different
laptops. No luck.
I wondered if the empty logfile is connected with the empty
GCS in some way. The Messages tool is blinking as it should and
at least the IR message contains updated data, so I found it a
bit strange that these data would not reach the logfile and GCS.
Could something in the configuration files that are editable
in Paparazzi Center (airframe, flight plan, settings etc) cause
this?
Also I wondered about the Entering 'log_xml'
line in Paparazzi Center that I cannot remember having seen
before. I could be wrong there.
I have the possibility to check this evening with my old
Paparazzi setup which was saved a few weeks ago. I know that one
worked fine.
After running git pull, make clean and make (last time
today) it seems I have got a problem which I have not
experienced before. The GCS wont populate, even though
the modems talk to each other.
The plane is a Multiplex Twinstar which has had many
Auto2 flights.
Symptoms:
GCS wont populate.
Telemetry seems to work with normal activity.
The Messages tools show normal activity.
IR sensors values changes as I move my hand around the
sensors.
Log file is empty.
In the main window in Paparazzi Centre there is a
message I cannot remember having seen before (not sure):
Entering 'log_xml'
I deleted the old conf.xml and control_panel.xml
before git pull and entered my personal aircraft and
session into the new files.