I have configured the Xbees, one as END DEVICE and the other as COORDINATOR, both AT and baudrate 57600, with same ID Number.
So, now i want read IMU values about telemetry, perhaps GPS datas.
Moreover i doesn t have a RC device now. But i think it should works even so or not?
I can build and compile without errors and execute the GCS. But there is just a black screen(no telemetry).
And in few seconds there are a Failure("pprz.values_of_payload, wrong agrument:00 08")
So what is this meaning and where is the mistake in the config. Does it generally work without RC? And what I also notice is, that just the LED 4 on the Lisa board blink, when it is not connect with USB to PC. No LED lightning at ON, Rx, Tx when power is on.
My second question is, how can I use this special GPS module, what config file is needing?