> Dear all,
>
> I encounter a really strange behavior on a fixedwing.
> I had a look at the logs, made a lot of flights in order to find out
> what's
> wrong, but I really don't understand what's happening.
> So here is the situation:
>
> First, the setup:
> Lisa/M 2.0, PPZ Version: 4.0.1. I'm using an airspeed sensor,
> I'm launching the plane with a bungee, in manual mode.
> Before launch, current clock is set to circle over home, 150m AGL.
>
> What's happening:
> After launch, when I change to AUTO2 , the plane does not pitch up with
> motor on as expected in order to reach the desired altitude, but pitches
> down, gaining airspeed and loosing altitude (I checked that airspeed is
> near or over desired airspeed when I switch mode).
>
> As things get dangerous, I switch to MANUAL, get some altitude, engage
> AUTO2, and the same behavior occurs.
> Then, after a few tries like this, everything works ! And it works really
> fine, as I have a very good airspeed control and climb rate.
> After that, I can switch from MANUAL to AUTO2, and the plane behaves
> normally (get some altitude at the right airspeed and climbrate).
>
> I did a lot of tests (I initially thought of a I-term winding up), all
> were
> unsuccessful.
> The only clue I found: this problem might be related to the airspeed
> specific control loops, because when I disable the airspeed sensor from
> the
> airframe config file the plane seems to behave correctly (no pitch down
> when engaging auto2).
>
> Did anyone encounter the same behavior ?
> Do you have any idea about what could be happening ?
>
> Of course, I can provide further details, setup and logs.
>
> Regards,
> Mitchell
_______________________________________________