[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Paparazzi-devel] lisa adc problem
From: |
Chris |
Subject: |
[Paparazzi-devel] lisa adc problem |
Date: |
Mon, 08 Oct 2012 21:59:10 +0300 |
User-agent: |
Mozilla/5.0 (X11; Linux i686; rv:15.0) Gecko/20120912 Thunderbird/15.0.1 |
Hi.
Now that i have setup almost everything a new kind of problem appeared.
I am using ADC3 for current measurements and the channel is working fine
but it needs a 2-3 Kohm pull down resistor because otherwise it floats
at 1.168v.
The only change i made was to move the ppm input from servo 6 to UART1
Rx, i will try the original
code tomorrow.
I am sure that it worked fine before and the board is clean.
Any ideas?
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Paparazzi-devel] lisa adc problem,
Chris <=