Re: [Paparazzi-devel] Does Paparazzi support PWM Radios?

[Andreas Philipp]

Hi Kevin,

have a look at
ftp://ftp1.digi.com/support/documentation/90002126_K.pdf
on page 14 on the left you see the pin numbering and on the next side 
you see the function of the pins.

You need pin 1 to 4:
1 -> gnd
2 -> vdd
3 -> dout(=tx on modem)
4 -> din(=rx on modem)

You can solder wires for connection directly on the modem (small but 
possible) or use a xbee interface board for smp which is included in the 
development kit (e.g. 
http://www.mouser.com/ds/2/111/90002127_A-472677.pdf, page 6 with 
special pins to clip and not to plug) which is expensive (I never have 
seen them stand alone). We also used some hard wire and clipped it over 
the pins (isolated on the opposit side pins).

Hope that helps ...

concerning the flash, may be someone experienced to LISA boards can help ...
Andreas

Am 15.04.2016 um 13:12 schrieb notoriou5:
> Hi Helge,
>
> thank you very much for your offer. I talked to my prof and he decided to
> buy a new Spektrum DX8. But Thanks a lot.
>
> But I already have a new problem :D
>
> I would like to connect my XBee 868 lp module with the LISA M but I do not
> have the RX and TX on the XBee, is there a way to connect via SPI?
>
> Thanks a lot,
>
> Kevin
>
>
>
> --
> View this message in context: 
> http://lists.paparazziuav.org/Does-Paparazzi-support-PWM-Radios-tp17895p17899.html
> Sent from the paparazzi-devel mailing list archive at Nabble.com.
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel