[Qemu-devel] [PULL 16/24] sd/sdhci.c: Only reset data_count on new commands

[Peter Maydell]

From: Peter Crosthwaite <address@hidden>

The data_count variable was being reset on every transfer, including
DMA transfer resumptions. This is incorrect, it should only be set
on a new command.

Manifests as a bug when using ADMA and there is a timer delay between
ADMA frames where the fifo is left in a non empty state.

Signed-off-by: Peter Crosthwaite <address@hidden>
Reviewed-by: Igor Mitsyanko <address@hidden>
Message-id: address@hidden
Signed-off-by: Peter Maydell <address@hidden>
---
 hw/sd/sdhci.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/hw/sd/sdhci.c b/hw/sd/sdhci.c
index 91dc9b0..0a84540 100644
--- a/hw/sd/sdhci.c
+++ b/hw/sd/sdhci.c
@@ -260,6 +260,7 @@ static void sdhci_send_command(SDHCIState *s)
     sdhci_update_irq(s);
 
     if (s->blksize && (s->cmdreg & SDHC_CMD_DATA_PRESENT)) {
+        s->data_count = 0;
         sdhci_do_data_transfer(s);
     }
 }
@@ -773,7 +774,6 @@ static void sdhci_do_adma(SDHCIState *s)
 static void sdhci_data_transfer(SDHCIState *s)
 {
     SDHCIClass *k = SDHCI_GET_CLASS(s);
-    s->data_count = 0;
 
     if (s->trnmod & SDHC_TRNS_DMA) {
         switch (SDHC_DMA_TYPE(s->hostctl)) {
-- 
1.7.9.5