[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [PATCH v3 4/4] sd: sdhci: Remove block count enable check i
From: |
P J P |
Subject: |
[Qemu-devel] [PATCH v3 4/4] sd: sdhci: Remove block count enable check in single block transfers |
Date: |
Sat, 11 Feb 2017 20:37:01 +0530 |
From: Prasad J Pandit <address@hidden>
In SDHCI protocol, the 'Block count enable' bit of the Transfer
Mode register is relevant only in multi block transfers. We need
not check it in single block transfers.
Signed-off-by: Prasad J Pandit <address@hidden>
---
hw/sd/sdhci.c | 6 +-----
1 file changed, 1 insertion(+), 5 deletions(-)
diff --git a/hw/sd/sdhci.c b/hw/sd/sdhci.c
index 99fa0c7..d612a80 100644
--- a/hw/sd/sdhci.c
+++ b/hw/sd/sdhci.c
@@ -569,7 +569,6 @@ static void sdhci_sdma_transfer_multi_blocks(SDHCIState *s)
}
/* single block SDMA transfer */
-
static void sdhci_sdma_transfer_single_block(SDHCIState *s)
{
int n;
@@ -588,10 +587,7 @@ static void sdhci_sdma_transfer_single_block(SDHCIState *s)
sdbus_write_data(&s->sdbus, s->fifo_buffer[n]);
}
}
-
- if (s->trnmod & SDHC_TRNS_BLK_CNT_EN) {
- s->blkcnt--;
- }
+ s->blkcnt--;
sdhci_end_transfer(s);
}
--
2.9.3