[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] reading two rx channels on usrp2
From: |
Tom Gross |
Subject: |
[Discuss-gnuradio] reading two rx channels on usrp2 |
Date: |
Tue, 26 Jan 2010 22:09:01 -0500 |
I am in the process of hacking up the usrp2 host and firmware to
support two receiver channels. I'm at the point where
"start_rx_streaming" is being acknowledged for channel 1 but there is
no data being returned for that channel. I don't actually understand
yet where the receiver data is packaged to be sent over the ethernet
(I haven't really looked into that yet) but I have been trying to
understand how which receiver channel is selected...
I'm guessing that the bits in rx_mux in dsp_rx_regs_t are used to
connect one of two DACs to one (or two?) inputs of the digital down
converter. I note that the current setting of rx_mux is 0x44444444
which I am guessing (based on the comments in memory_map.h) could mean
"constant 0" for one input and "DAC A" for the other input to the
DDC... Am I interpreting that correctly? Can anyone give me some
hints as to what the setting would be if I want to enable both
channels? Any other insights as to how to access both channels in the
USRP2 firmware?
-Tom
- [Discuss-gnuradio] reading two rx channels on usrp2,
Tom Gross <=