[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] USRP2 printing of character "S" bothersome!!

From: Marcus D. Leech
Subject: Re: [Discuss-gnuradio] USRP2 printing of character "S" bothersome!!
Date: Thu, 11 Nov 2010 17:32:38 -0500
User-agent: Mozilla/5.0 (X11; U; Linux i686; en-US; rv: Gecko/20101027 Fedora/3.0.10-1.fc12 Thunderbird/3.0.10

On 11/11/2010 04:57 PM, Bishal Thapa wrote:
  I am using USRP2 version of BBN code to look at AP beacons as seen by the USRP2 host. There is lots of "S" printing going on, which keeps me from reading AP beacon information from STDOUT (unless I save the output to a file, which I prefer not to). Is there anyway to enforce the printing of "S" character to go away. Here is my node's specification:

My ubuntu version = 10.04
GNuradio version = 3.3.0

Keep in mind, though, that those 'S' indicate that your host is being overrun by the USRP2.
  An occasional one isn't a problem, but if you're getting a lot of them, it will affect your
  Rx performance quite a bit.

I think of an occasional 'S' as the same as an occasional "RFI hit" on the channel.  But when
  the rate of them gets to the point where you're losing a significant amount of Rx data, it's
  a problem.

Principal Investigator
Shirleys Bay Radio Astronomy Consortium

reply via email to

[Prev in Thread] Current Thread [Next in Thread]