boost lexical cast doesnt have a very telling error does it...
Can you send me the complete verbose?
Does the error happen when you run uhd_usrp_probe?
Howabout uhd.single_usrp_source?
Does GDB give any hint as to where the exception is thrown?
Thanks,
-Josh
On 11/26/2010 04:05 AM, Tobias Schmid wrote:
Hello,
I'm trying to use 2 USRP2 using the UHD Driver.
My version is the git version of yesterday.
But when I'm trying to build a flowgraph using grc,
gnuradio isn't able to run the generated code.
The following error occurs:
RuntimeError: bad lexical cast: source type value could not be interpreted as
target
And this is the generated code:
self.uhd_multi_usrp_source_0 = uhd.multi_usrp_source(
device_addr="addr=192.168.10.2 192.168.10.3",
io_type=uhd.io_type_t.COMPLEX_FLOAT32,
num_channels=2,
)
_clk_cfg = uhd.clock_config_t()
_clk_cfg.ref_source = uhd.clock_config_t.REF_SMA
_clk_cfg.pps_source = uhd.clock_config_t.PPS_SMA
_clk_cfg.pps_polarity = uhd.clock_config_t.PPS_POS
self.uhd_multi_usrp_source_0.set_clock_config(_clk_cfg, uhd.ALL_MBOARDS);
self.uhd_multi_usrp_source_0.set_time_unknown_pps(uhd.time_spec_t())
self.uhd_multi_usrp_source_0.set_samp_rate(1000000)
self.uhd_multi_usrp_source_0.set_center_freq(2450000000, 0)
self.uhd_multi_usrp_source_0.set_gain(20, 0)
self.uhd_multi_usrp_source_0.set_center_freq(2450000000, 1)
self.uhd_multi_usrp_source_0.set_gain(20, 1)
Can someone help me solving this problem?
Best regards,
Tobias
Neu: WEB.DE De-Mail - Einfach wie E-Mail, sicher wie ein Brief!
Jetzt De-Mail-Adresse reservieren: https://produkte.web.de/go/demail02
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio