[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] preload a signal onto USRP

From: Anisha Gorur
Subject: Re: [Discuss-gnuradio] preload a signal onto USRP
Date: Wed, 8 Aug 2012 09:07:37 -0400

It was for use in a multi-usrp configuration, but actually no longer necessary. Thank you both!

On Tue, Aug 7, 2012 at 4:57 PM, Robert Cicconetti <address@hidden> wrote:
If you really needed to use a USRP as a standalone signal generator you could probably encode the signal into a hardware block on the FPGA, depending on how much in the way of resources are left unused. It would be much more work than the file source method mentioned earlier. Why do you want it preloaded? Low latency?

-R C

On Tue, Aug 7, 2012 at 4:38 PM, Anisha Gorur <address@hidden> wrote:
Hello All,
I have a bit of a strange question. Is it possible to somehow preload a signal (it would be periodic) onto a USRP so that I would only have to send a signal saying "begin transmit", and it would do so, without sending anything besides the "begin transmit" message over the Ethernet cable? I've been searching around and I haven't found anyone who wanted to do something like this.


Discuss-gnuradio mailing list

Anisha Gorur
Class of 2012
Electrical Engineering

reply via email to

[Prev in Thread] Current Thread [Next in Thread]